If you have a 3D printer, congratulations!, you can print your own Humbot!
You can find the design files in Pinshape following this link:
You’ll have to follow your printer instructions and settings. However, we help you with the settings we used:
- Material: PLA
- Layer height: 0.2mm
- Supports: not needed
- Print speed: 20mm/s bottom, top and outer shell. 40mm/s general speed.
- Shell thickness: 1.2mm (making 3 shells with 0.4 nozzle)
- Top/bottom thickness: 0.6mm
- Print time: around 12h with these settings (it may seem too much but it’s worth it ;))